RobotiX Part Manipulators
RobotiX part manipulators allow you to scan more parts quicker for reduced cycle times and increased productivity. Scanning parts with complex geometries can require you to get scans from different angles. If done manually, someone is required to reposition parts and possibly change out fixtures. Time is wasted as each time the X-ray tube shuts off and the door has to open and close. Our RobotiX part manipulators can eliminate wasted time by repositioning parts as needed for each scan.
Dual RobotiX
Our Dual RobotiX precision technology features two robot arms working in harmony of movement to scan large parts. Set-up and operation of our our Dual RobotiX system is effortless through a simple interface that allows the operator to easily create new robotic motion programs. RobotiX motion programs are created through NSI’s efX-DR acquisition software. Our patented software allows the operator to program the robot and configure the image acquisition parameters all through a single software interface so your operators don’t have to learn another software program. Our simple interface allows operators to X-ray inspect large parts using 6-degrees of motion at any given point. The results — image accuracy, less complex fixturing and faster turnaround times.
X7000 RobotiX Automated Industrial CT Scanning System
Specifications
Fanuc M-2000iC/210F Robot
- 210 kg (462 lb) max payload
- 6 Axis
- Reach & capacity dependent upon application
- Up to ±0.00079 in (± 0.02 mm) repeatability
Robot mounted to the base of the X7000 manipulator
Manipulator in front of cabinet, robot in the back
Supports pneumatic tool changer
Cabinet extended by 48″ compared to the standard X7000 system
- Increased freedom of motion compared to conventional manipulator systems
- Allows for the capture images on complex parts which may have previously required film exposure or complex fixturing
- Ability to maneuver the tube or detector within cavities to support single wall exposures resulting in an improved image quality
- Increased throughput by providing the ability to acquire images of complex parts with less door cycles and manual repositioning
- Less need for complex fixture design, reducing time and cost to setup and support inspections
- Full control of the robots is provided through NSI’s motion and imaging software
- Increase in safety by reducing the need for operators repositioning large parts
- Seamless integration with efX-DR
- X-ray Energies from 10 kV – 450kV
- Minimum Focal Spot Size: ~2 μm
- Nominal Part Envelope: 60 x 60 in [152 x 152 cm]
- Maximum Focal Distance: 90 in [228 cm]
X7000 RobotiX Automated Industrial CT Scanning System
Downloads
X7000 RobotiX Automated Industrial CT Scanning System
Applications
- Failure Analysis
- Assembly Verification
- Reverse Engineering
- Density Analysis
- Finite Element Analysis
- Void and Porosity Analysis
- 2D and 3D Metrology
- Internal and External Measurements
- Product Quality Compliance
- Research and Development (R&D)
- 3D CAD comparisons
- Weld and Braze Quality Analysis
- In Situ Monitoring
- Additive Manufacturing System Qualification
X7000 RobotiX Automated Industrial CT Scanning System
Automated CT Scanning System
Have a question? Want a demo?
X-Ray Training
Looking for technical training programs?
Service & Support
- Preventative Maintenance
- 12 Point Inspections
- On-site Repair & Service
- Relocation Support
More RobotiX
